BETCO XT3 Operator's Manual download pdf (Page 7)

Procedures for Loading, Transporting, and Unloading

Battery Burnisher

The machine is very heavy, so be very careful when loading,

transporting, and unloading the machine. Use at least two

people to load or unload the machine.

x Loading Procedure Using a Ramp

o It is not recommended that the battery burnisher be loaded using a

ramp with an incline of more than 7 degrees. The machine is not

self-propelled and therefore it is not able to assist itself up a ramp.

It is too heavy to manually push up a steep incline.

o If you must load with a ramp, the incline must be no more than 7

degrees. (This would permit a height of no more than one foot for

an 8-foot ramp).

o Ramp must be secured to vehicle, and be clean and dry.

o Machine must be pushed or pulled straight up the ramp and never

at an angle.

x Loading Procedure Using a Lift Gate

o Lift gate must have ample capacity to lift the burnisher.

o Wheels must be firmly chocked to prevent burnisher from rolling off

the lift gate.

x Securing Battery Burnisher

o Burnisher must be secured, so that it will not roll or turn over. Use

chocks and tie downs to secure.

o Please be aware that the battery burnisher is very heavy, and that a

metal bulkhead in a van may not contain equipment in the event of

an accident. The equipment in a van can be more dangerous than

the accident itself.

x Unloading Procedure Using a Ramp

o Ramp must be long enough so that removal can be controlled. Use

same ramp incline restrictions as used for loading burnisher.

o Ramp must be secured to vehicle, and be clean and dry.

o Machine must be taken straight down the ramp and never at an

angle.

o Do not let machine run over you or anyone else as it comes off

ramp.

BETCO CORP. 6/22/07 Page 7 XT3 BATTERY BURNISHER

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

No comments

BETCO XT3 Operator's Manual Page 7